Spiral Tube & Fittings
Spiral galvanised ductwork & fittings in a large range of sizes.
Our ductwork complies to DW144 standard. The UK recognised specification of how to manufacture and install ductwork. Spiral ducting is made for transporting air - it supplies fresh air into buildings & extracts excess & stale air out of buildings. Spiral duct is much more effective in terms of less air leaks then rectangular ducting due to less joints because of its large 3m lengths. Spiral ducting can be used to carry air up to temperatures of around 200◦c at a continual temperature & around 250◦c if the temperature is intermittent. If used above recommended temperatures, discolouring can happen & corrosion can occur.
We can offer advice over the phone or email. Other products not listed are also available so please enquire via email orders@alphatube.co.uk
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF
End Caps
Cap ends made from galvanised steel with male ends to fit inside spiral ducting. Cap ends are used to terminate ducting runs. Available in sizes ranging from 63mm – 630mm. Bigger sizes available by phone or email enquiries.
*Please note* some of the more uncommon sizes may have a larger lead time.
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF
Volume Control Damper
Volume Control Damper made from galvanised steel. The dampers have male ends to fit inside ducting or other female fittings. They are used for manually balancing the flow of the air in ducting runs with a single circular blade. Bigger sizes available by phone or email enquiries.
*Please note* some of the more uncommon sizes may have a larger lead time.
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF
Blast Gate Damper
Manufactured from cast aluminium with a galvanised shut off blade. These circular dampers are ideal for use on extract systems in the woodwork industry where by you can shut off parts of a system that are not in need of a constant flow.
T-Piece 90 Degree Branch
T-piece 90-degree branch to suit spiral tubing, made from galvanized steel. Male ends to fit in spiral ducting or flexible tube. Available in sizes ranging from 63mm – 710mm. Bigger sizes available by phone or email enquiries.
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF
Mesh Ends
Mesh end caps made from galvanized steel. Tabbed ends to fit on the outside of spiral ducting. Available in sizes ranging from 63mm – 710mm. Bigger sizes available by phone/email enquiries and may have a different connection.
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF
Cowl
Weather cowls made from galvanised steel and fit over spiral ducting. Weather cowls are made for terminating ducting, whilst stopping rain & animals from getting inside the ducting run. Available in sizes ranging from 63mm – 630mm. Bigger sizes available by phone or email enquiries.
*Please note* some of the more uncommon sizes may have a larger lead time.
DISCOUNT OFFER
BUY OVER 5 PRODUCTS - 10% OFF
BUY OVER 10 PRODUCTS - 20% OFF